For a few days I made a steampunk hat and I decided to make a tutorial of the progress. I normally don't dress up as a steampunk and sorry if i break any specific rules. But I really like how it turned out.
If you have any questions feel free to ask!
1. Materials
The materials I decided do use is foam, contact glue (decided to use a glue gun instead because I was in a hurry), black and gold paint (think I used acrylic paint), a chain, a black ribbon and some LED lights.
I was suppose to use the green thing to make some decor but then I change my mind.
2. Cut out the parts
Use a part of thick foam (mine was 1cm) and cut out the parts for the base of your hat.
It can be a bit tricky to take out the perfect size of the part. I had 56 cm around my head and made a square 59*12cm and two different circles one withe a hole in the middle. Make sure that the square fits around the smaller circle and inside the whole of the bigger one. Don't really know how to describe it but take a look at the photo and you will understand. (the square is much higher than 12 cm! made it smaller after the photo!)
If you are not sure what size you wanna make your hat I recommend to try make one in paper first.
3. Make a base of the hat
Glue everything together with hot glue or contact glue so it looks like this.
Make sure that it fits your head.
4. Prepare lights
Make a hole in the hat and put the lights through it.
5. More foam!
Take the fin foam (2mm) and cut it in different square.
Glue it on the hat base until it is totally covered with the thin foam
Remember to keep a hole for the light so you can put them on later.
6. Painting
You can pain the hat in what color you like but i started with a black base. remember to also paint the inside.
Then I use a gold color and use a big brush (I actually use an old make up brush but use what you have at home) and then just very little color and put all over the hat. The messier the better so don't be to pedantic about it.
I also did the same to the black ribbon and there you can also se the brush that I was using.
7. Decoration
You can decor your hat however you want. I attach the ribbon around the hat and the LED around. I also decided to put on a chain on the front to make it look more awesome.
8. Battery
To keep the battery in place I just made a little box with some leftover foam and a ribon that I glued in the top of the hat.
9. Finish!
Try your new hat and be proud of what you have created. ;)